CUT SHEET
Florida's best Standing Seam Fabricator and Supplier. Serving Roofing Contractors and Builders in South Florida, Eastern Florida and Central Florida.
Send us your cut sheet so we can provide you a non-obligation estimate for your metal roofing project.
|
On your Cut Sheet, please provide us the following:
- Roof System of interest and roof pitch; - Chosen color on the drop down (color chart here); - Feet length and quantities of Field Panels; Observation: All trims are 10 feet long. You may inform us the total linear feet length or the total amount of 10 feet long pieces. Make sure to consider the your waste factor. - Provide the quantities to cover the necessary Ridges and Hips (roof slope angles); - Provide the quantities to cover the eaves with Bullnoses (Drip Edge) and angles; - Provide the quantities to cover W Valleys (w/ angles and quantities); - Provide the quantities of Zee Closures; - Provide the quantities for end Wall Flashings, Transition Flashings, Stucco Stops, etc.; - Provide the quantities and sizes of all roof penetrations (Goose Necks, Boots, etc.) If we need additional information we will contact you. Thank you. |
Disclaimers:
*Oil canning phenomena is a naturally occurring condition for sheet metal products. It may be prominent due to unevenness of the decking. This condition is not a defect and shall not be considered a cause for rejection.
**All returns are subjected to Management approval and may incur 25% restocking fee.
***Any order discrepancies must be informed within 48 hours of delivery.
****There is no warranty for steel panels installed within 1500 feet from salt water and brackish water.
*Oil canning phenomena is a naturally occurring condition for sheet metal products. It may be prominent due to unevenness of the decking. This condition is not a defect and shall not be considered a cause for rejection.
**All returns are subjected to Management approval and may incur 25% restocking fee.
***Any order discrepancies must be informed within 48 hours of delivery.
****There is no warranty for steel panels installed within 1500 feet from salt water and brackish water.